AS NZS 5000.1 1999 Electric cables—Polymeric insulated Part 1 For working.pdf

AS/NZS5000.1:1999
(Incorporating Amendment No. 1)
zN0m
Australian/New Zealand Standard
Electric cables-polymeric insulated
Part 1: For working voltages up to and
including 0.6/1 kv
stand ardsaustra: ia STANDARDS
AS/NZS 50
999
Ihis Joint Australian/New Zealand Standard was prepared by Joint Technica
Committee EL/3, Electric Wires and Cables. It was approved on hehalf of the
Counci] of Standards Australia on 18 November 1999 and on behalf of the Council
of Standards New Zealand on 22 November 1999. It was published on 5 December
1999
The following interests are represented on Committee EL/3
Australasian Railway Association
Australian Electrical and Electronic Manufacturers Association
Australian Industry Group
Department of Defence, Australia
Department of Mineral Resources, N.S. W
Electrical Contractors Association of New Zealand
Electricity Supply Association of Australia
nstitution of Engineers. Austral
Ministry of Commerce, New Zealand
New Zealand Manufacturers Federation
Regulatory Authorities (Electrical
esting interests, Australia
Keeping Standards up-to-datc
Standards are living docume
thich reflect progress in science, technology
systems. To maintain their currency. all Standards are periodically reviewed, and
new editions are published. Between editions, amendments may be issued
Iso be withdrawn. I
nportant that readers a
themselves
they are using a current Standard, which should include any amendments which
may have been published since the Standard was purchased
Detailed information about joint Australian/New Zealand Standards can be found b
Visiting
Standards Austra
siteatwww.standards
New Zealand web site at wwwstandardco nz and looking up the relevant Standard
Alternatively, both organizations publish an annual printed Catalogue w
details of all current Standards. For more frequent listings or notification o
revisions. amendments and withdrawals. Standards Australia and Standards New
Zealand offer a number of update options. For information about these services
uscrs should contact their respective national Standards organization
We also welcome suggestions for improvement in our Standards, and especially
enco
nrage readers to notify us immediately of any apparent
accuracies o
ambiguities. Please address your comments to the Chief Executive of either
Standards Australia International or Standards New Zealand at the address shown
on the back cover
This Standard was issued in draft form for comment as DR 97396
祖国万岁上传