ETSI TS 100 392-18-1 V1.4.1 (2008-07).pdf

ETSI TS 100 392-18-1 V1.4.1 (2008-07) Technical Specification Terrestrial Trunked Radio (TETRA); Voice plus Data (V+D) and Direct Mode Operation (DMO); Part 18: Air interface optimized applications; Sub-part 1: Location Information Protocol (LIP) ETSI ETSI TS 100 392-18-1 V1.4.1 (2008-07) 2 Reference RTS/TETRA-03188 Keywords air interface, location, TETRA, V+D ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16 Siret N 348 623 562 00017 - NAF 742 C Association but non lucratif enregistre la Sous-Prfecture de Grasse (06) N 7803/88 Important notice Individual copies of the present document can be downloaded from: http:/www.etsi.org The present document may be made available in more than one electronic version or in print. In any case of existing or perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF). In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at http:/portal.etsi.org/tb/status/status.asp If you find errors in the present document, please send your comment to one of the following services: http:/portal.etsi.org/chaircor/ETSI_support.asp Copyright Notification No part may be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in all media. European Telecommunications Standards Institute 2008. All rights reserved. DECTTM, PLUGTESTSTM, UMTSTM, TIPHONTM, the TIPHON logo and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members. 3GPPTM is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. ETSI ETSI TS 100 392-18-1 V1.4.1 (2008-07) 3 Contents Intellectual Property Rights.8 Foreword.8 1 Scope.9 2 References.9 2.1 Normative references .9 2.2 Informative references.10 3 Definitions, symbols and abbreviations .10 3.1 Definitions.10 3.2 Symbols.10 3.3 Abbreviations.10 4 Location information protocol.11 4.1 General.11 4.2 Location information protocol system architecture.12 4.3 Location information protocol service description.15 4.3.1 General on services.15 4.3.2 Services available at the LIP-SAP.15 4.3.3 Service primitives at the LIP-SAP.16 4.3.4 Service primitive parameters at the LIP-SAP.17 4.5.5 State description.17 5 Location information protocol description.17 5.1 Description of information elements.17 5.1.1 General on accuracies and uncertainties.17 5.1.2 Acknowledgement request.17 5.1.2a Backlog information elements.17 5.1.3 Basic parameters.17 5.1.4 Confidence level.17 5.1.5 Direction of travel and direction of travel accuracy.18 5.1.6 Horizontal position and horizontal position accuracy.18 5.1.7 Horizontal velocity and horizontal velocity accuracy.18 5.1.8 Location altitude and location altitude accuracy.18 5.1.9 Location information destination.18 5.1.10 Location message reference.19 5.1.11 Location shape.19 5.1.12 Maximum information age .19 5.1.13 Maximum reporting distance.19 5.1.14 Maximum reporting interval.19 5.1.15 Maximum response time.19 5.1.16 Minimum reporting interval.19 5.1.17 Reason for sending.19 5.1.18 Report type.20 5.1.19 Request priority .20 5.1.20 Requested/required.20 5.1.21 Start time.20 5.1.22 Stop time.20 5.1.23 Terminal or location identification .21 5.1.24 Trigger definition.21 5.1.25 Trigger type .21 5.1.26 Velocity type.21 5.1.27 Vertical velocity and vertical velocity accuracy.21 5.2 Information flows.22 5.2.1 General on information flows.22 5.2.2 Pre-programmed MS sending reports.22 5.2.3 Pre-programmed MS sending reports and receiving acknowledgement.22 ETSI ETSI TS 100 392-18-1 V1.4.1 (2008-07) 4 5.2.4 MS receiving basic parameters.23 5.2.5 MS receiving basic parameters and sending response.23 5.2.6 MS reporting basic parameters .24 5.2.7 MS receiving immediate report request and sending response.25 5.2.8 MS receiving immediate report request and asking acknowledgement.25 5.2.9 MS receiving trigger definitions and sending reports.26 5.2.10 MS receiving trigger definitions and sending reports and asking acknowledgements.27 5.2.11 MS receiving trigger definitions and sending modification.28 5.2.12 MS receiving trigger definitions and rejecting triggers .28 5.2.13 MS receiving trigger definitions and sending reports to other location information destination.29 5.2.14 MS receiving trigger definitions via location server and sending reports to another location information destination.30 5.2.15 Trigger removal.31 5.2.16 Trigger reporting.31 5.2.17 Location reporting enabling.32 5.2.18 Location reporting disabling.32 5.2.19 Location reporting temporary control.33 5.2.20 Backlog information flows .34 5.2.21 Allocation of